Hotline / Zalo: 033 44 13586
Stay connected:

No. 3 – How to Bump test GasAlertMicroClip XL


Bump test GasAlertMicroClip XL What is Bump test a gas detector? Bump test is checking responsibility of gas sensors and alarm trigger checking. Why need Bump test? We need ensure that detector still work well before use, because it is safety equipment. Almost maker recomment user doing Bump test each day before use. Prepare for


No. 2 – Turn ON/OFF 4 gases detector GasAlertMicroClip XL


Turn ON/OFF 4 gases detector GasAlertMicroClip XL Generally, Turn ON/OFF a 4 gases detector are the same way, only manipulation are diffrent between a maker The general principle of turning on a gas detector is as follows: Fully charging before use. If low battery, some function may work in-correct. Press and hold Power button until unit


BW GasAlertMax XT II – No. 3: Change Pump to Diffusion mode


Pump to Diffusion mode Portable gas detector GasAlertMax XT II by BW Honeywell is unique gas detector can be easy change from Pump mode to Diffusion mode without remove internal pump. When need check a “Confined Space”, user assembly tubing then put down tubing probe to closed space for detect gas inside. When user need


BW GasAlertMax XT II – No.2: Instruction for use video


GasAlertMax XT II – Instruction for use BW GasAlertMax XT II can be detect 4 gases: LEL/O2/CO/H2S simultaneously BW GasAlertMax XT II integated internal pump for Confined space function up to >20m Each Turn ON time, this portable gas detector required pump test by block pump then un-block pump. If pump work well, it indicated PUMP


MSA Altair 4XR gas detector: Video 7 – Motion Alert


MSA Altair 4XR – Motion Alert To activate or deactivate the Motion Alert feature, press the “UP” button while the Motion Alert Activation page is displayed. When the Motion Alert feature is active, the Motion Alert symbol will flash every 3 seconds. The device will enter pre-alarm when no motion is detected for 20 seconds. This


MSA Altair 4XR gas detector: Video 6 – Calibration


Calibration MSA Altair 4XR Prepare calibration equipment: A MSA Altair 4XR gas detector (Normal operation) Gas cylinder with correct type of gas inside Valve regulator Tubing (normally, supply with gas detector) Calibration cap (normally, supply with gas detector) Processing calibration: Step 1: Assemby valve regulator and tubing to Gas cylinder Step 2: Active calibration function


MSA Altair 4XR gas detector: Video 3 – Setting up


Setting up for MSA Altair 4XR Fully understanding a equipment before use always the most importance. Video below will be instruct user how to setting up almost parameter inside MSA Altair 4XR ie: Sensor settup, Calibration settup, Alarm settiup… Some parameters need quality person, who really deepply understand this unit and safety standards for setting

Phone: 024 668 13586
Fax: +84 024 6675 4433
905 C6-K2, My Dinh 1, HN
Thibft kế web bởi